SATA AE5736, User Manual, Page: 12 / 18

中文
EN
AE5736/AE5737
12
（
Back View
）
Left side view
8. Storage box
9. Spray gun interface
10. Power interface
11. Control line connection (gun switch control interface)
12. Air inlet
Chapter
Ⅱ
Operating Instructions
Preparation of machine and equipment before start-up
- Take out two high pressure airtight hoses in the machine case. One of the hoses with control line is the outlet hose
connecting the main engine with the cleaning spray gun, and the other is the intake hose of the main engine.
- Connect the air intake hose to the air inlet (at the back of the machine) and the external air source, which should be
firmly connected to prevent air leakage; The standard diameter of the external air source pipe is national standard
1\2"; The high-pressure airtight hose of this machine has GB 1\2" internal wire thread, so the external air supply port
should match GB 1\2" external wire connector.
- Connect the outlet cleaning hose to the cleaning spray gun and the main machine of the cleaning machine, and
ensure the connection is firm; At the same time, correctly connect the air plug on the control line of the associated
spray gun and the host.
- Check whether the external power supply meets the requirements, and then connect the power supply and socket;
Turn on the power switch and make sure the power indicator on the control panel is on. The device is in standby
mode.
- After entering the standby state, pay attention to the number displayed on the "frequency adjustment" of the software,
which should be controlled between 10-20 during normal cleaning; It is strictly prohibited to adjust the frequency
below 10, if so, the machine and equipment will not have dry ice airflow output.
Machine equipment operation cleaning function
- Add dry ice particles (diameter ≤3mm) into the feeding port of the machine with ice shovel (randomly attached).
- Choose suitable nozzles.