ES
PT
JA
RU
EN
DE
KO
中文
AE3001/AE3002/AE3003/AE3004/AE3005/AE3006/AE3007/AE3008/
AE3009/AE3010/AE3015/AE3016/AE3017/AE3018/AE3019
13
5. Installation of End Cap
5.1 Insert the locating pins at the six positions on the inner side of the end cap into the gourd holes on the side of
the reel. If the end cap is attached flat on the side of the reel without gap observed, push the side plate carefully
in the direction indicated in the figure to integrate the end cap with the reel, and check whether there is a gap in
the fitting position.
※
Note: The side plate can be pushed only after the end cap is attached flat on the side of the reel
without gap. Otherwise, the locating pins on the end cap would be broken by brute force
5.2 In this way, install the end caps respectively at both ends of the combined reel. Now the fixing and fitting of the
reel is completed.
5.3 To remove the end caps, push the end caps in the direction opposite to that in the figure above. Refer to the
labels on the reel.
AE3001八国-200621.indd 13
AE3001八国-200621.indd 13
2020/6/23 12:59:02
2020/6/23 12:59:02