SATA AE1021, User Manual, Page: 56 / 340

56
AE1021/AE1021-3/AE1021H/AE1021H-3 ES PT JA RU EN DE KO
中文
Chapter III Operation Guide
- Do not use the machine until you have read and understood the entire instructions and the warnings therein. Before the operation,
release the air from the tire and remove all lead blocks from the wheel.
- The operation of the tire changer includes the following parts: a) tire leaning; b) tire dismounting; c) tire mounting.
3.1 Tire leaning
- Before operation, make sure all the original lead blocks are removed, remove the valve core, and check the deflation of tires.
- Place the tire between the tire pressing shovel and the tire pressing rubber pad, and then step on the tire pressing pedal to separate the
tire bead from the rim. Repeat the above operations on other parts of the tire to completely separate the tire beads on both sides from
the rim. Place the wheel with the tire bead separated from the rim on the rotary table, step on the clamp pedal to clamp the rim (The
inside clamp or outside clamp can be selected according to the rim), and prepare to dismount the tire.
3.2 Tire dismounting
- Apply the supplied grease (or similar grease) on the tire opening. Failure to use grease will cause serious damage to the tire opening.
- Never put your hand under the tire while locking the rim. The correct fixing operation enables the tire to be just located in the center of
the crankset to ensure that the rim is firmly fixed to the claw.
- Place the hexagon shaft in the working position to make the mounting head closely abut against the upper edge of the rim. Use the knob
to hold the rocker arm against it. Then lock it up with the locking handle. The mounting head will automatically move up little clearance.
The angle of the mounting head has been adjusted according to the standard rim when leaving the factory. In case of extra large or small
rims, please relocate.
2mm
2mm