Operating Instructions Bar Cooler Model BCD 2100
4. Preparation for use
•
Clean the bar cooler, the adjustable grids and the glass doors with a moist rag and a mild
cleaning detergent. Dry everything carefully. The glass panes can be cleaned with a
cleaning detergent for windows. Do not use aggressive detergents, steel wool or high
pressure cleaner or a jet of water. (See also under point 6 “Cleaning”)
•
Put the plug into the plug socket.
•
Allow the appliance to operate for about 1 hour to cool the compartment before placing
items in the bar cooler.
•
Do not throw items onto the shelves and do not place items totaling more than 30 kg on
each shelf. The shelf could fall down, possibly cause injury.
•
The products should have room temperature (not too warm or hot).
•
The distance of the grids should suit the products height.
•
Place the products in a proper way into the bar cooler, so that nothing falls out, if you
open the door.
•
Place not too much into the bar cooler, because of the air circulation.
•
Do not block the air intake openings and the air discharge outlets in the bar cooler.
•
Avoid unnecessary opening of the door.
•
Ensure the door is properly closed at all times.
•
During power failure open the door rarely and for short time only. Do not insert further
food.
•
Defrosting is performed automatically. Drain water is collected in the drain tray, where it
evaporates automatically.
5. Operation
Down at the front side is the control panel with display, one SET-key and 2 arrow keys.
Beside the control panel is a light switch for the interior lighting.
Features of Functions
▲
It increases the value of the parameter
▼
It reduces the value of the parameter
SET
Indicator of the set-point value and programming of the parameter value
1. After putting the plug into the socket, the display shows the temperature of the bar cooler
interior.
2. If you press the set-key now, the LED-display flashes on, and the adjusted cooling tem-
perature is indicated. With the arrow keys (
▲
or
▼
) you can change this temperature
level. The new set cooling temperature is confirmed by pressing the SET-key or you wait
several seconds and the new set cooling temperature is automatically taken over.
3. To switch on the interior light, operate the light switch.
4. The operating control lamp lights up during the cooling phase and shut off, if the cooling
temperature is constant.
5. Note: If you do not need the bar cooler for a long time, pull the plug from the socket and
clean everything as described under point “Cleaning”. Leave the glass door open, so that
no smells develop on the inside.
page 3
