Operating Instructions - Bottle Cooler with Sliding Lid
Operating
1.) The temperature in the cooler is automatically regulated by a preadjusted thermostat.
2.) You also can set the rotary knob to a lower temperature, if you turn the knob to the right.
3.) The position of the cooler, the ambient temperature, the number of times the lid is
opened and for how long, all these factors affect the temperature in the cooler, which
should therefore not be placed in sunlight or close to a heat-radiating surface.
Manual defrosting
In the course of time, a frost layer will naturally form within the cooler.
When this layer is 3 – 5 mm thick, the cooler should be defrosted in the following way:
1. remove the plug from the socket.
2. open the lid and leave it open.
Note: The defrosting process can be speeded up by using bowls of hot water.
Never use sharp or pointed instruments.
After final defrosting, the cooler should be cleaned as follows:
Cleaning and maintenance
For hygenic and functional reasons the cooler should be cleaned regularly, as decribed
under “installation no. 4”. Then clean also the condenser. Food stains, which have
overflowed, are to be wiped off immediately.
Before each cleaning the appliance must be switched off, by pulling the plug from the plug
socket.
During the cleaning of the condenser proceed as follows: Brush the dust off, deposited at the
front surface of the condenser, and remove it with the vacuum cleaner.
Note: If the cooler is not used for longer time, pull the plug from the plug socket, clean the
appliance and leave the door a little bit open.
Trobleshooting
a) If the cooler does not function.
Check, whether the connection of the power supply plug is correct with the plug socket.
If the cable is damaged, it must be exchanged by a qualifield specialist.
b) If the desired interior temperature is not reached:
Check, whether the temperature is correctly adjusted?
Is the cooler in the defrosting stage or thereafter?
Is the evaporator covered with ice?
Is the condenser blocked (e.g. by dust)?
Is the condenser too little ventilated?
Does the cooler stand near to a heat source (furnace etc.)?
Can the sliding lid be correctly closed?
d) If the appliance makes noises:
Check, whether the appliance has loose screws or nuts within.
Does the appliance stand in balance?
Despite all these controls the appliance exhibits further problems, inform your dealer
.
Page 2
