Installation Instructions
Mortise Lock
IN100 Series
IN100 Series
Mortise Lock
Installation Instructions
16 1-800-810-WIRE • www.sargentlock.com • A8190E
02/28/21
1-800-810-WIRE • www.sargentlock.com • A8190E 17
Copyright © 2016, 2020-2021, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
6
Lock Installation continued
10 Install inside component assembly (controller)
(6) AA
Batteries
Controller
Fig. 10A
Fig. 11
a. Insert bottom tab of controller -
(ensure path is clear) into slot on mounting plate. (Figure 10A)
b. Ensure proper alignment of board-to-board connectors while pivoting controller
toward door until two tabs on top click
securely into place on mounting plate.
(Figure 10B)
a. Place six (6) “AA” alkaline batteries in compartment, being careful
to align polarity properly. (Figure 11)
b. After batteries are installed, there is a slight delay; then red and
green flash*, audible “beep” and lock motor will cycle.
*See Section 8 - LED Indications
for more information.
CAUTION: To avoid possible damage to
board-to-board connectors, care should be
taken when securing controller to mounting
plate. If there is resistance when securing,
detach controller to determine cause before
re-attaching controller.
11 Install batteries
Click
into
place
Fig. 10B
