16
Conquest Spas
OWNER'S MANUAL
5. After the pumps are primed turn off by pressing the Jet(s) button(s). Next manually exit
the priming mode by pressing either the
Warm
or
Cool
button. After you have manually
exited the priming mode the display will show the set temperature, which defaults at
100° F/ 37°C, followed by two dashes (--). This will last for two minutes while the water
temperature is determined. Push the
Warm
or
Cool
button to the desired setting.
6. Re-install filter cover and allow spa to heat to desired set temperature: this normally
takes 24 hours.
7. Water must be balanced and shocked upon start-up. See your dealer or pages 26-28 of this
manual for details. This procedure must be repeated each time the spa is drained and refilled.
8.
The Whisper Clean® Jet
The combination of the Whisper Clean® and Vortex Jet™ return systems help the
Whisper Clean® System to circulate water from the surface and bottom level of the spa.
The Whisper Clean® Jet also introduces temperature controlled water and ozone into the
spas footwell area 24 hours a day. A slow or non-moving Whisper Clean® Jet may indicate
that the filter cartidges areobstructed with dirt, body oils or calcification. Follow the filter
cartridge cleaning procedures in this manual.
It is recommended to press and release the Residual Current Device (RCD) RESET
button monthly to verify RCD is working properly.
Important:
A pump should not be allowed to run without priming for more than 2 minutes. Under NO
circumstances should a pump be allowed to run without priming beyond the end of the 4
minutes priming mode. Doing so may cause damage to the pump and cause the system to go
into an overheat condition.
Whisper Clean® Jet
!
!
17
Conquest Spas
OWNER'S MANUAL
EQUIPMENT MAINTENANCE
Conquest Spas Jet Valve Maintenance
After a period of time it may become difficult to adjust and rotate the valves. It is necessary to
clean the valves to ensure that they continue to perform well. The following instructions will
walk you through the steps.
1. Turn power off to the spa.
2. Un-thread valve cover by turning valve cover counter clockwise.
3. Remove complete valve assembly, by pulling outward.
4. Clean or remove debris from valve or diverter.
5. Re-assemble and re-thread valve cover.
Roto Stream™ Valve Maintenance*
The Roto Stream™ valve is another unique feature that Conquest Spas use for Hydrotherapy.
It is necessary to clean the valve to ensure that the Roto Stream™ valve continues to perform
well. The following instructions will walk you through the steps in cleaning the valve and
cleaning the built in cup strainer. It is recommended to clean the Roto Stream™ valve every
time you drain your spa.
*Victory Series:
Realm, Laurel, Elation, Baroque
Replacing the Spa’s Light Bulb
The spa’s light bulb is located inside the equipment compartment . Remove the front access
panel, by first removing the screws on the access panel . Then locate the light housing mounted
to the spa shell . Grasp the bulb holder on the back of the light niche . Turn bulb holder counter
clockwise to release it from the light niche . Pull bulb out of receptacle and replace it with a new
light bulb, available at your Conquest Spas dealer . Re-attach the light bulb holder to the light
niche by turning the light bulb holder clockwise .
