26
4. At this point, turn power on to the spa control system by turning on the GFCI breaker.The MSPA
operations center will begin heating the spa to the factory set temperature of 95ºF (35ºC).
5. The next step is to check that the jet system(s) are operational. Press on the Jet(s) button to turn
on the pump(s).A strong force of water flowing through the jets indicates the pump(s) are primed.
Weak or surging jet(s) indicates the pump(s) still need to be primed (see Troubleshooting section).
6. Once pump(s) are primed, close the air bleeder valve(s) in the filter compartment.
Note:
Water will be exiting from the air bleeder valves.
7. Re-install filter cover and allow spa to heat to desired set temperature; this normally takes 24
hours. 110 Volt models may take up to 48 hours to reach desired set temperature.
8. 24 hours after initial start-up the spa will go through its first power filtration cycle. Jets 2 (pump 2),
Jets 3 (pump 3) and optional Blower will run on high speed for one (1) minute.Then Jet 1 (pump 1)
will turn on and run on low speed for one (1) minute.This power filtration cycle is repeated every
24 hours at the exact time as initial power-up.
Note:
If water bubbles are not coming out of the Whisper Clean® Jet/bottom drain, the
system is air locked. Refer to the Trouble Shooting Section on page 60 for further instructions.
Note:
It is recommended to press and release the ground fault circuit interrupter (GFCI)
RESET button monthly to verify GFCI is working properly.
Note:
If power is interrupted, and the conserve filtration cycle has been activated, it will be
reset to the continuous 24 hour cycle.
9. Water must be balanced and shocked upon start-up. See your
dealer or pages 57–59 of this manual for details.This procedure
must be repeated each time the spa is drained and refilled.
10.
The Whisper Clean® Jet
The combination of the Whisper Clean® and Vortex Jet™ return
systems help the Whisper Clean® System circulate water from
the surface and bottom level of the spa.The Whisper Clean® Jet
also induces temperature controlled water and ozone into the
spas footwell area 24 hours a day.
Note:
A slow or non-moving Whisper Clean® Jet may
indicate that the filter cartridge pores are obstructed with
dirt, body oils or calcification. Follow the filter cartridge
cleaning procedures in this manual (See page 53).
