_
English
_
3.
Insert the main plug into the wall socket. The indicator light will turn on.
4.
When the indicator light goes out you may start ironing.
5.
If you set the temperature control to lower setting after ironing at a high
temperature, it is not recommended to iron before the pilot light switches on
again.
WATER TANK FILLING
1.
Unplug the iron before filling the water tank.
2.
Hold the steam iron in horizontal position.
3.
Slowly pour water through the water inlet.
4.
Do not fill higher than mark on the water tank, in order to avoid spilling out of
water.
NOTE:
Your steam iron is designed to use tap water. However, if the water is very
hard, it is advisable to use distilled water.
The water tank should be emptied after each use.
NOTE:
If you empty the water tank after the steam iron has cooled down, set the
steam iron in upright position on its heel rest, plug it in and set the temperature
control dial to the maximum position, heat for 2 minutes. Unplug the steam iron from
the power supply.
SPRAYING
As long as there is enough water in the water tank, you may use the spray button at
any temperature setting during steam or dry ironing.
Press the spray button several times to activate the pump while you are ironing.
STEAM IRONING
1.
Set the temperature control dial to the “..” or “…” position.
2.
Set the variable steam control to the desired position.
CAUTION:
Avoid coming in contact with ejected steam.
DRY IRONING
1.
The steam iron can be used on the dry setting with or without water in the water
tank, it is best to avoid having the water tank full while dry ironing.
2.
Turn the variable steam control to the minimum position.
3.
Select the setting on the temperature control dial best suited for the fabric to be
ironed.
CAUTION:
If the steam iron has been used for a long time, it is hot and there is no
water. Do not refill it with water until the steam iron cools down.
