SETTINGS
The illustration shows the factory default settings for the switches in the camera setup section.
Depending on the camera installation location and conditions of use, it may be necessary to select
other settings, without having to make adjustments. The selected settings can be confirmed using
the on-screen menu. If adjustments are required, they can be entered using on-screen adjustment
sub-menus (see
ADJUSTMENTS
, page
14
).
2
3
4
1
ON
6
7
8
5
9 10
2
3
INT
1
OFF
7
8
OFF
OFF EI
I
R
I
S
AI
ON
ES
LL ON ON
WB
BLC
SYNC FL AGC
High speed electronic shutter (ES) setting
Normally, the three speed setting switches (1, 2 and 3) for the
high speed electronic shutter are all set to the
OFF
position. This
sets the electronic shutter speed to 1/60 sec. The three switches
in the camera setup section can be set as indicated in table
A
to
select one of the 8 speeds available.
Notes:
•
When using the high speed electronic shutter, the
BLC
switch
must be set to the
OFF
position.
•
Using the high speed electronic shutter indoors with low
lighting, will give darker pictures. In such a case, add some
lights to make sure the lighting is sufficient. If the lighting is
very bright, pay attention to the light angle in order to avoid
or minimize the smear phenomenon effect.
•
If IRIS is set to
EI
(electronic iris mode), then the high speed
electronic shutter speed will not correspond to the set speed.
u..
