SETTING THE RS-232C OR RS-485 DATA TRANSFER SPEED
Data Transfer Speed Setup
1
Press the MENU button until the (SET UP 3) menu
is displayed.
@@@@@@@<SET@UP@3>
*ALARM@MODE@@@@@@@Y1
*ALARM@SPEED@@@@@@3H
*ALARM@DURATION@@@20S
*EXT@TIME@ADJ.@@@@01:00
*TAPE@IN@MODE@@@@@STOP
*TAPE@END@MODE@@@@REW
*TAPE@END@OUT@@@@@-3M
*CLOG@DETECT.@@@@@Y
*SERIES@REC@IN@@@@N
*RS-485@@@@@@@@@@@19200
2
Turn the JOG dial, until the “RS-485” or “RS-232C”
setting is flashing.
NOTE:
X
The display will depend on the DIP switch 9
setting. When down “RS-232C” is displayed and
when up “RS-485” is displayed.
3
Turn the SHUTTLE ring to set the desired transfer
speed.
4
Press the SEARCH/AUDIO ON button to save the
setting.
RS232C 9-pin connector layout
Pin
number
Signal
Operation
Signal direction
2
RXD
Receive
data
VCR
←
Computer
3
TXD
Send data
VCR
→
Computer
7
RTS
Request
to send
VCR
→
Computer
5
GND
Signal
ground
The signal transmission is compatible with RS-232C
specifications.
RS485 RJ-11 connector layout
NOTE:
Do not connect to phone line.
Pin number
Connector A
signal
Connector B
signal
1
Not used
Not used
2
Not used
Not used
3
A
B
4
B
A
5
Not used
Not used
6
Not used
Not used
A: Non-inverting driver output/receiver input
B: Inverting driver output/receiver input
RS-485 Connection
This VCR can use the straight type or crossed type
connecting cables.
If using a straight type cable, connect it from the “A” to
the “A” or from the “B” to the “B” RS-485 connector.
If using a crossed type cable, connect it from the “A” to
the “B” or from the “B” to the “A” RS-485 connector.
Types of cables
Straight type:
A cable with pin connection number
correspondence (i.e. pin 1 to pin 1, pin
2 to pin 2, etc.).
Crossed type:
A cable without pin connection number
correspondence.
2400
4800
9600
19200
1
5
9
6
1
6
RE4QS/EX (TLS-S8000P GB) Wed. May, 23/2001
38
English
