- 12 -
Condenser lens
Integrator lens
Prism
Screen
Cleaning Procedure
(When no good, progress to next step.)
1. Clean surface of optical parts using air spray.
2. Wipe the dry cleaning with wiping cloth and the wiper.
3. Soak a few medicines in the cloth as follows and wipe up them lightly. After that,always wipe the dry cleaning
cloth.
Optical parts
Medicines
Remarks
LCD panel
Iso-propyl-alcohol
Be sure to handle this part with special attention.
Pay attention to static electricity. Do not touch
the electrode of flexible cables.
Polarized glass
(Glass with plastics sheet)
Methanol
Synthetic detergent
Iso-paraffin liquid
Wipe up lightly.
Because there is fear that the film comes off the
substrate when wiping up by the strong power.
Dichroic mirror
Optical filter
(Glass with the surface coat)
Alcohol
(methanol:ethel=8:2)
Ethanol
Recommendation medicine
Wipe the dry cleaning with wiping cloth and the wiper.
Soak a few medicines in the cloth as follows and wipe
up them lightly.
After that,always wipe the dry cleaning cloth.
Projection lens
Ethanol
Disassembly Cleaning
Disassembly cleaning method should only be performed when the unit is considerable dirty and cannot be suffi-
ciently cleaned by air spraying alone.
Be sure to readjust the optical system after performing disassembly cleaning.
Caution :
The surface of the optical components consists of multiple dielectric layers with varying degrees of refraction.
Never use organic solvents (thinner, etc.) or any kind of cleanser on these components.
Since the LCD panel is equipped with an electronic circuit, never use any liquids (water,etc.) to clean the unit.
Use of liquid may cause the unit to malfunction.
After long periods of use,dust and other particles will accumulate on the LCD panel,prism,mirror,polarized glass,
lens,etc.,causing the picture to darken or color to blur. If this occurs,clean the inside of optical unit.
Remove dust other particles using air spray. If dirt cannot be removed by air spray, disassemble and clean the
optical unit.
Caution:
Use a commercial (inert gas) air spray designed for cleaning camera and computer equipment.
Use a resinbased nozzle only. Be very careful not to damage optical parts with the nozzle tip. Never use any kind
of cleanser on the unit. Also, never use abrasive materials on the unit as this may cause irreparable damage.
●
Optical parts care and cleaning
Synthetic detergent
ver u
ce the
e orga
LCD
se organ
e
nic sol
panel
a
an
p
e
(thinn
pped
er,
wit
er etc.)
h an
or an
electr
y kind
nic
of cle
rcuit
anse
eve
on th
use
ese c
any liq
qui
nent
(water,etc.) to clean
●
O
Opti
O
al parts
s care and clea
aning
on
enti
atte
ial
pec
h sp
art
s pa
h
dle
an
to h
re t
s
Be
