Sanyo PLC-XT20, Owner'S Manual

Page: 65 / 83

65
Maintenance and Filter Cleaning
When the projection lamp of the projector reaches its end
of life, the Lamp replacement icon appears on the screen
and LAMP REPLACE indicator lights yellow. Replace the
lamp with a new one promptly. The timing when the LAMP
REPLACE indicator should light is depending on the lamp
mode.
Follow these steps to replace the lamp.
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering, give the following information to the dealer.
●
Model No. of your projector : PLC-XT25, PLC-XT25L, PLC-XT25K,
PLC-XT21, PLC-XT21L, PLC-XT20, PLC-XT20L
PLC-XT20K
●
Replacement Lamp Type No. : POA-LMP105
(Service Parts No. 610 330 7329)
For continued safety, replace with a lamp of the same
type lamp. Do not drop the lamp or touch the glass
bulb! The glass can shatter and may cause injury. Allow a projector to cool for at least 45 minutes
before you open the Lamp cover. The inside of
the projector can become very hot.
CAUTION
Turn off the projector and unplug the AC power cord.
Let the projector cool for at least 45 minutes.
Remove the two (2) screws that secure the lamp. Lift
the lamp out of the projector by using the handle.
1
3
Replace the lamp with a new one and secure the two
(2) screws. Make sure that the lamp is set properly.
Put the lamp cover back and secure it with the screw. 4
Remove the screw that secures the lamp cover, and
then open the lamp cover.
2
Connect the AC power cord to the projector and turn
on the projector.
6
Reset the lamp counter.
See “Resetting the Lamp Counter” on the next page.
5
Lamp Replacement
CAUTION
Screw
Lamp replacement icon
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER
Top Control
Handle
Screws
LAMP REPLACE
indicator
Lamp cover