Sanyo PLC-XT20, Owner'S Manual

Page: 18 / 83

18
Projection angle can be adjusted up to 5.0 degrees with the
adjustable feet.
Rotate the adjustable feet and tilt the projector to the proper
height; to raise the projector, rotate the both feet clockwise.
To lower the projector or to retract the adjustable feet,
rotate the both feet counterclockwise.
To correct keystone distortion, press the KEYSTONE button
on the remote control or select Keystone from the menu
(see pages 15, 32, 50).
Adjustable Feet
Adjustable Feet
Part Names and Functions
To insure safe operation, please observe the following precautions :
●
Use two (2) AAA or LR03 type alkaline batteries.
●
Always replace batteries in sets.
●
Do not use a new battery with a used battery.
●
Avoid contact with water or liquid.
●
Do not expose the remote control to moisture or heat.
●
Do not drop the remote control.
●
If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
●
Risk of an explosion if battery is replaced by an incorrect type.
●
Dispose of used batteries according to the instructions.
Press the lid
downward and slide it.
Open the battery
compartment lid. Install new batteries
into the compartment. Replace the
compartment lid.
Two AAA size batteries
For correct polarity (+ and –),
be sure battery terminals are
in contact with pins in the
compartment.
1 2 3
Point the remote control toward the projector (to Infrared
Remote Receivers) when pressing the buttons. Maximum
operating range for the remote control is about 16.4’ (5 m)
and 60 degrees in front and rear of the projector.
Infrared Remote Receivers are provided both in front and
back of the projector. You can conveniently use both of the
receivers (see pages 10, 57).
Remote Control Receivers and Operating Range
Remote Control Battery Installation
16.4’
(5 m)
16.4’
(5 m)
✔
Notes:
•When hanging the projector from the ceiling, select the Infrared
Remote Receiver which is located farther away from the
fluorescent light. (see page 57)