Sanyo PLC-XM80, Owner'S Manual, Page: 48 / 89

48
Use the Point t u buttons to adjust the gamma value to obtain a
better balance of contrast (from 0 to 15).
Press the Point t button to decrease the sharpness of the image;
press the Point
u
button to increase the sharpness of the image
(from 0 to 31).
An interlaced video signal can be displayed in progressive mode.
Press the Point
t u buttons to change the progressive scan mode.
Off ........... Progressive scan mode is Off .
On ........... Progressive scan mode is On .
Film ......... For watching a film. With this function, the projector
reproduces pictures faithful to the original film quality.
Noise interference on the screen can be reduced. Press the Point
t u buttons to change the noise reduction mode.
Off ........... Noise reduction mode is Off .
On ........... Noise reduction mode is On .
P Note:
• Noise reduction and Progressive cannot be selected when
Video delay control is set to On (p.61).
• Progressive cannot be selected when 480p , 575p , 720p or
1080p is selected (p.45).
• Noise reduction cannot be selected when 1080p is selected
(p.45).
To reset the adjusted data, select Reset and press the SELECT
button. A confirmation box appears and then select yes . All
adjustments will return to their previous figures.
To store the adjusted data, select Store and press the Point u or
the SELECT button. Use the Point pq buttons to select one from
Images 1 to 10 and press the SELECT button.
A confirmation box appears and then select
yes . Stored data can
be called up by selecting an Image (1-10) in the Image Mode
Selection on page 46.
A confirmation box
appears and then
select
yes .
Store
Video Input
Press the Point t button to lighten red/green/blue tone of the black
level of an image; press the Point
u
button to deepen red/green/
blue tone of the black level of an image (from 0 to 63).
Offset(Red/Green/Blue)
Sharpness
Gamma
Noise reduction
Progressive
Reset
Store