2
DIN FRONT-MOUNT (METHOD A)
Installation with the rubber bushing
1. Dashboard
2. Half Sleeve
After inserting the sleeve into the
dashboard, select the appropriate tabs
according to the thickness of the
dashboard material, then bend them
outward to secure the sleeve in place.
3. Screw
Installation without the rubber bushing
1. Dashboard
2. Nut (5mm)
3. Screw (5 x 14mm)
4. Strap
Be sure to use the strap to secure the
back of the unit. The strap can be bent
by hand to the desired angle.
Removing the unit
1. Removable Trim Ring
2. Grasp the center area of the trim ring
from the top or bottom edge, then pull
outward to remove it. (When reattaching
the trim ring, carefully align it with the
front panel of the unit, then press it
into place.
3. Levers
Insert the levers supplied with the unit
into the grooves on both sides of the
chassis (as shown in the figure) until they
click into place. Carefully pull outward
to remove the unit.
1
3
2
182
53
1
2
4
3
1
2
3
