• In
treble
mode:
While “TRE” is shown on display, press ‘ ’ to increase treble level, and press
‘ ’ to decrease the level.
The treble level is updated correspondingly and its status is shown on display.
• In
balance
mode:
While “BAL” is shown on display, press ‘ ’ to shift sound level to right speaker,
press ‘ ’ to shift sound level to left speaker.
The shift point is updated correspondingly and its status is shown on the
display.
• In
fader
mode:
This function controls the balance between front and rear speakers of 4 speakers
system.
While “FAD” is shown on display, press ‘ ’ to shift sound level to front
speakers, press ‘ ’ to shift sound level to rear speakers.
The shift point is updated correspondingly and its status is shown on the
display.
5.
MUT (=MUTE)
Press the button to cut the sound output and LCD display will indicate “MUTE”
and flash. Press any button to release the mode and recover the previous volume
level.
6.
LOU (=LOUDNESS)
Press the button to reinforce the bass especially when listening at low volume
level, and LCD display will indicate “LOUD”. Press it again to release the mode.
7.
DSP (=DISPLAY)
During radio operation, press the button to recall the time display. Pressing it
again or activating any tuning function, will cause the display return to station
frequency read-out.
Time Setting
Press and hold DSP button, then press the tune buttons ‘
+
’ side to adjust the
minute, ‘
–
’ side to adjust the hour.
8.
BND (=BAND)
Press the button to switch the reception broadcast band in following order:
9.
LOC (=LOCAL/DISTANT)
Press the button to switch to reception of local station with strong signals or
distant stations with weak signals. The unit is initially set to distance mode.
Press the button to switch into local mode and LCD display will indicate “LOC”.
Press it again to release the mode.
Note: This function is in effect during AUTO SEEK or AMS operation.
10. SCN (=SCANNING)
Press SCN button to set the function to scan mode, which scans for higher
frequency stations with receivable signals and stays on each station for several
seconds. During the period of scanning, press it again to stop scanning and
release the mode.
9
FM1
FM2
FM3
AM1
AM2
