LENS REPLACEMENT AND INSTALLATION PROCEDURE
Remove screws A (2 screws).
Pull down the lower lens cover while pushing
the part D, then remove it.
Remove screws B (2 screws).
Remove screws C (2 screws) and remove
upper lens cover.
1
5
Perform the steps
to
for lens replacement and installation.
1
1.
2.
A
Fig-1
Fig-2
Remove 2 screws and pull down the plate.
2
3.
4.
UPPER LENS COVER
LOWER LENS COVER
C
B
D
D
COVER PLATE
REMOVE THE LENS COVER. (See figure-1)
(At the step
, insert the light-block sheet in
the same position as the removed cover plate
has been placed. Two screws are not used.)
4
REMOVE THE COVER PLATE OF THE LENS COVER. (See figure-2)
INSTALL THE LENS. (See figure-3)
Remove protective caps(front and
back) on the lens.
Mount the lens on mounting brack-
et of the main cabinet with 4
screws.Use the screws included
with the lens.
Use the driver included with the
lens to fasten the screws.
(After using, save it for latter use.)
Connect the lead connector of the
lens motor to the “K16B” on the
circuit board as shown in figure-4.
Fasten the lens motor lead at the
A, B points with wire holder as
shown in figure-4.
3
1.
2.
LENS MOUNTING BRACKET
ATTACHED DRIVER
Fig-3
3.
4.
LENS MOTOR
