Sanyo LCD-24XAZ10F, Instruction Manual, Page: 7 / 29

Identification of Controls
Main Unit (back view)
Main Unit (front view)
1. Remote sensor
2. Power indicator
Lights blue when in operating mode.
Lights red when in standby mode.
3. POWER
4. INPUT
To access Input menu
5. MENU
Press this button to access the main menu screen.
6. CH
Press these two buttons to directly change the TV channel;
In menu operations, these buttons serve as up/down buttons.
7. VOL+
Press the VOL+ or VOL– button to directly increase or
decrease the sound volume level;
In menu operations, these buttons serve as right/left buttons.
Receives signals from the remote control.
Do not block.
Press this button to turn the unit ON from STANDBY mode.
Press it again to turn the set back to STANDBY.
^
/
^
/–
Note: Buttons on the TV control panel are touch
buttons. First touch of the button will illuminate it.
Second touch will fulfill its function.
Be sure button
presses must be quickly done before the
illumination disappears and it is suggested to touch
the sensor center, otherwise the operation may
not fulfill successfully.
5
1 2
INPUT MENU CH VOL
+
3 4 5 6 7
INPUT MENU CH VOL
1
2
3
11
4 5 6 7 8 9 10
U
S
B
S
C
A
R
T
PC IN
AUDIO VGA
S-VIDEO
RS-232
AV OUT
VIDEO L AUDI O R
Y
C /P
r r
C /P
b b
AUDI O
HDMI
1. USB port: Connect a USB device to this port.
2. Headphone: Connect headphones to this jack.
3. SCART: Connect a device with SCART connector to this
socket.
4. HDMI: Connect an HDMI device to this jack.
5. PC IN VGA/AUDIO: Connect a computer to these
jacks.
6. RS-232: For service only. Do not use.
7. S-VIDEO: Connect a S-Video output from a video device
to this jack.
8.
9. COMPONENT IN: Connect a component video device
to these jacks.
10. RF: Connect an antenna or cable TV to this jack.
11. AC IN : Plug the AC cord into this jack and into a power
outlet.
AV OUT: Connect a VCR to these jacks to record
program’s video.