Sanyo LCD-19XR9DA(C), Service Manual

Page: 20 / 51

Table 5 Factory software burned instructions
No. Part No. Part Type
Software
function
Burned
before SMT
Burning method
N103 5272564002
IC_EN25Q64-104HIP
FLASH Yes
Use ALL11 with write-protect, refer
to Note 1 in detail.
N106 5272404002 AT24C04 HDCP KEY Yes ALL11
N301 5272402002 AT24C02 HDMI EDID Yes ALL11
N316 5272402002 AT24C02 HDMI EDID Yes ALL11
N305 5272402002 AT24C02 VGA EDID Yes ALL11
Note 1:
Method of
w
rite-protect setup: enter into burning interface of ALL-100, cross option
“
Config
”, press item “
config Setting
”, set option “
Protect
” as “
All Protect
”; make sure that
option “
Config
” must be crossed before burning software and write-protect must be reset
after ALL-100 burning software opened every time.
Note 2:
Method of burning and upgrading software by using ISP burning device:
Main board upgrade: Connect 4-core line of ISP burning device to Debug port (
X107
) of main board;
Unit upgrade: Connect both VGA ports of ISP burning device and main board, enter into factory menu
and set item “
ISP Mode
” as “
ON
”;
1
）
Using
Mstar
online burning device (
V4.4.2.0
or higher versions), enter into menu “
Device
”, cross
option “
WP Pin pull to high during ISP
” to ensure that hardware write-protect of Flash is
removed and erasing process is normal, please refer setup to Fig. 15;
Fig. 15 Write-protect setup
2
）
Press menu “
Connect
”, a dialog box “
Device Type is MX25L64
” will pop up, that is, connection
has been successful, please refer to Fig. 16;
Method of software upgrading
instructions