Sanyo KH1242, Instruction Manual

Page: 26 / 64

OI-404-02 - 6EG
2 - 6
Operation Controller with Receiver (Separated
from Indoor Unit) for K and U Types
A: Operation controller You can operate this air conditioner using the
(separated from indoor unit) operation controller without the wireless remote controller.
B: Remote control receiver This section picks up infrared signals from the wireless remote controller
(transmitter).
C: ON/OFF operation button This button is for turning the air conditioner on and off (automatically setting
cooling or heating operation).
D: SWEEP button Use this button to make the airflow direction sweep up and down
automatically.
E: SERVICING switches These switches are used only when servicing the air conditioner.
Do not use these SERVICING switches for normal operation.
F: Switch Usually set this switch in to the NORMAL position.
G: ADDRESS switch When operating the air conditioner by using the wireless remote controller, be
sure to match the number on this switch with the number set on the wireless
remote controller. Otherwise, the remote control will not work.
H: OPERATION lamp This lamp lights when the appliance is turned on.
I: TIMER lamp This lamp lights when the system is being controlled by the timer.
J: STANDBY lamp When the unit is in the heating standby condition, the STANDBY lamp lights.
K: FILTER lamp This lamp lights when the filter needs cleaning.
Turning off the ON/OFF operation button does not
disconnect the power. Use the main power switch to turn off
the power completely.
B: Remote control receiver
C: ON/OFF operation button
D: SWEEP button
E: SERVICING switches
G: ADDRESS switch
F: Switch
H: OPERATION lamp
I: TIMER lamp
J: STANDBY lamp
K: FILTER lamp
A: Operation controller
2
2 RCS-SH80UA.WL 5/2/01 2:18 PM Page 6