- 12 -
HEC-FX1/RX1
Replacement Procedure
(7) Replacement of Control
1, Take off the arm rest (right). Photo-1,2,3
2, Remove two control set screws on the rear
of a stay (control), disconnect a connector
connected to the PCB (control) and take off
the control. Photo-11,12
3, Remove three case (control lower) set
screws, take off latches of two libs and take
off the case (control lower). Photo-11
4, Remove two PCB (control) set screws and
take off the PCB (control). Photo-13
5, Remove eleven cover (arm rest) right set
screws and take off the cover (arm rest)
right. Photo-12
6, Disconnect the processing of connector
assembly B. Photo-14
7, Remove eight stay (arm rest front / rear)
right set screws and take off the part of arm
rest (upper). Photo-14
8, Remove two stay (control) set screws and
take off the stay (control). Photo-11
9, Remove seven arm rest assembly (upper)
set screws and take off the arm rest
assembly (upper). Photo-15
10, Remove one stay (arm rest rear) right set
screws and take off the stay (arm rest rear)
right. Photo-15
11, Take off the connector assembly B.
Photo-15
Photo-11
Case set screws
Control set screws
Stay (control)
Case (control lower)
Photo-14
Stay (arm rest front)
Stay (arm rest rear)
Stay set screws
Stay set screws
Stay set screws
Photo-15
Cover set screws
Arm rest assembly (upper)
Photo-12
Conector assembly B
Conector assembly B
Cover set screws
Conector
Control
Photo-13
PCB set screws
PCB (Control)
Stay (arm rest front) right
Stay (arm rest rear) right
Stay set screw