Sanyo DC-F320, Service Manual

Page: 10 / 56

CDCHANGERREPLACEMENT
10. SETTING UP THE TRAY HOLDER AND UP/DOWN DRIVE GEAR
UP/DOWN DRIVE GEAR
1.
2.
3.
4.
5.
6.
7.
Loosen and install the SET SCREW of the SENSOR P.W.B.
Slide the TRAY HOLDER SLIDE forward until it goes no
further.
Align the round mark on the UP/DOWN DRIVE GEAR 1
with the mark area on the TRAY HOLDER SLIDE, and install.
Secure the screw.
As shown in the figure, place the UP/DOWN DRIVE GEAR
2 and UP/DOWN CAM GEAR 2 a way that they are
horizontal.
UP/DOWN CAM GEAR 2
l
Set the parts in such a way that the round marks on the two
GEARS are horizontal.
Align with the triangular mark through the hole through which
the UP/DOWN CAM GEAR 2 teeth are visible.
Secure the SCREW of the SENSOR and GEAR.
11. TRAY HOLDER SLIDE
UP/DOWN MOTOR
UP/DOWN DRIVE GEAR 2
J
(6142670440)
1
MOLYKOTE, EM-SOL
SG-7 SAN GREASE, SG-7
G-4748 OIL, G-4748
I
L
CD MECHANISM ADJUSTMENTS
1. REPLACEMENT AND LUBRICATION OF THE CD MECHANISM
2. CD BASE MECHANISM
SPINDLE MOTOR
SLED RETARD GEAR
SLED RETARD GEAR 2 PICK RACK GEAR
MOTOR LIMIT SW
SLED