Sanyo AVC-100, Installation And Operation Manual

Page: 7 / 65

9 10
TO CONNECT THE PARKING BRAKE CONNECTOR CABLE (2)
●
Using the self lock connector.
(Example)
Parking
brake lamp
Parking brake
switch
Close the self-lock
connector securely.
Parking brake signal line
Put it into the self-lock connector
Self-lock
connector
Parking brake connector cable
Insert the cable end into the self-lock connector.
When you connect the parking brake connector cable, set the parking brake and stop the engine.
Car may move and an accident may result.
t
CAUTION
¡ The TV/video signals appear only after you park the car and set the parking brake. When the car starts
moving, the TV/ video signals automatically disappear for safety reasons.
¡ If the parking brake signal line is too thin, connect the parking brake connector cable to the parking brake
signal line directly without using the self-lock connector.
¡
After finish attachment and connection, please check whether brake lamps, back lamps, horn, and blinkers
operate correctly.
Hint
CONNECTION (1)
*1. First connect the black ground lead, then connect the yellow and red power input leads.
*2. Depending on what antenna you are using, connect either to the control terminal of the motor aerial, or to the power
terminal for the booster amplifier of the film-type antenna.
Note:
If there is no accessory position (ignition ACC 12 V red wire), connect to the +12 V power (continuous 12 V
yellow wire) terminal which is energized at all times.
To rear right RCA output
To rear right speaker
To rear left RCA output
To rear left speaker
To front right RCA output
To front right speaker
To front left RCA output
To front left speaker
To ground *1
To battery
(continuos
+
12V)
Digital output
To car antenna
To TV tuner unit
(sold separately)
To rear view camera
or video device
(sold separately)
Subwoofer out
(MONO)
To video deck,
game etc.
To rear monitor etc.
To ignition
(ACC
+
12V)
To car's illumination
signal
To
+
12V power
terminal of the back
lamp lead of a car
To AMP REMOTE IN
of an optional
power amplifier
To the power aerial
control lead *2
To parking switch wire
FUSE
(10A)
Red
White
Red
White
Purple
Purple/Black
Green
Green/Black
Gray
Gray/Black
White
AUX3
AUX2
REAR MONITOR OUT
White/Black
Black (0.35m)
Orange/White (0.2m)
Purple/White (0.5m)
Blue/White (0.2m)
Blue (0.2m)
MAX. supply current 0.3A
MAX. supply current 0.1A
Light Green (0.25m)
Red (0.2m)
Yellow (0.35m)
Power supply cable
INST
ALLA
TION
MANU
AL
#AVC-100(GB)P000〜043 05.6.27 1:20 PM ページ9