II - 3
n
Change engine oil
Replace all oil in the oil pan and the sub tank.
) Prepare the designated amount of oil.
Amount of oil for 10,000 hours
Oil tank: 43 liters
Engine: 3 liters
2) Stop the engine after warming up for between 10 and 15
minutes.
(Refer to Section 1. (4) “
k
Stopping the Engine”.)
3) Open the cap of the oil tank (Figure 5).
4) Remove oil using the oil pump.
First, insert the pump in the narrow side of the oil tank aper
-
ture to remove oil from the external tank.
Next, insert the pump in the wider side of the oil tank to
remove the oil from the internal tank (Figure 6).
* Caution: For the narrow side, a tube of ø16 mm or below is
required.
5) Remove the caps that are inserted at the ends of the discharge
hose (2 in total) attached to the oil tank to remove the re
-
maining oil in the oil tank (Figure 7).
6) Once the oil discharge is complete, use a waste cloth to wipe
off the old oil from the outlet of the oil drain hose. After this,
insert the caps that were removed during Step 5). Bring the
oil drain hose back to its original position.
7) Use the oil container to slowly fill 43 liters into the oil tank
from the oil tank aperture and 3 liters into the engine via the
engine head. When doing so, fill the oil from the wider side
of the oil tank aperture (Figure 6).
8) Close the oil tank cap and the engine head cap.
o
Operation check
) If oil spilled while adding it, wipe it up.
2) Cancel the engine stop. (Refer to Section 1. (4) “
l
Canceling
Engine Stop.”) Operate the engine for 10 - 15 minutes and
make sure there are no oil leaks around the oil filter or oil
drain hose.
p
Oil level gauge check
Make sure that the oil is filled up till the divider is not visible
from the oil tank aperture.
q
Engine oil use time reset
Refer to Section 1. (4) “
m
Engine Oil Time Reset Method.”
Figure 7
Figure 5
Figure 6 Top surface of the oil tank
Oil tank
Wider side
Narrow side
