SANY SY95C, Operation And Maintenance Manual

Page: 114 / 166

5-16
MAINTENANCE
SY95C Excavator OMM
Right Front Access Panel
0003985
Figure 5-13
1. Use the key to unlock (1) and open the right front
access panel (2) to access the front storage
compartment. The panel also provides access to the
front work light (3) for maintenance.
2. Close the access panel and secure using the key
lock.
Fuses
Access the Fuse Panel
If an electrical component fails, check the fuse first. The
fuse and relay box is located behind the operator’s seat.
0004533
Figure 5-14
NOTE: Always turn the battery disconnect switch to OFF
before checking or replacing fuses. See “Battery
Disconnect Switch” on page 3-21.
1. Move/tilt the seat forward to provide room to access
the fuse access panel (1).
2. Push in on bottom of latches (2) and remove the fuse
access panel.
0004534
Figure 5-15
3. Remove the transparent protective cover (3) by
gently pulling out on the bottom of one of the four
latches (4) while lifting up the adjacent corner of the
cover. Repeat for the other three tabs to release the
cover.
4. Install the protective cover and fuse access panel by
placing them in position and pushing on them until
they lock in place.
Fuse Replacement
0002857
Figure 5-16
1. Use the fuse removal and installation tool (1) to pull a
blown fuse and install a new fuse.
2. Spare fuses (2) can be used for replacing a blown
fuse. Always replace a fuse with a fuse of the same
amperage rating.
1
2
3
1
2
3
4
4
K5
K8
K6
K12
K13
K9
K3
K7 1
2