internal batteries are exhausted, and they must be
immediately replaced.
For replacement, see Note
below.
After the pointer is properly adjusted, the test leads
are opened and are applied across the resistance to be
measured. (Fig. 4-6)
e Scale Reading.
Use the top black scale marked
Q
for all resistance measurements. (Fig. 4-7;
For the R x l range, read the figures directly.
For the RxlO , RxlOO and Rx lK ranges, read the
figures multiplied by 10, 100 and 1000, respectively.
Note. (1) Replacement of the batteries.
Put the
meter face down on a soft cloth, and loosen
the bolt on the back to remove the case.
To take out the batteries, the fixing bolts on
the minus sides are loosened.
After the batteries are replaced, do not tighten
the bolts too much, or the holder w ill be
cracked or the batteries punctured.
Be care
ful not to allow dust to get into the meter
while the batteries are replaced.
— 21 —