SANUS VuePoint F215B, Instruction Manual, Page: 9 / 38

6902-002025 <01>
9
2 Mount the Wall Plate
Solid concrete or concrete block
2-1 Mark the wall
2-2 Drill pilot holes
2-3 Insert anchors and lag bolts
75 mm
(3 in.)
CAUTION:
Avoid potential injuries or property damage!
Ù
Pilot holes MUST be drilled to a depth of 75 mm (3 in.) using a 10
mm (3/8 in.) diameter drill bit.
Ù
Never drill into the mortar between blocks.
Insert lag bolt anchors [09] . Then insert lag bolts [11] through the
washers [10] and the wall plate [01] and into the anchors.
CAUTION:
Avoid potential injuries or property damage!
Improper use could reduce the holding power of the lag bolt. To
avoid potential injuries or property damage:
Ù
Be sure the anchors [09]
are seated fl ush with the
concrete surface.
Ù
Tighten the lag bolts [11]
only until the washers
[10] are pulled fi rmly
against the wall plate [01] .
Ù
DO NOT over-tighten the lag
bolts [11] .
Level the wall plate [01] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage!
Ù
Mount the wall plate [01] directly onto the concrete surface.
Ù
Minimum solid concrete thickness: 203mm (8 in.)
Ù
Minimum concrete block size: 203 x 203 x 406 mm (8 x 8 x 16 in.)
[09]
10mm
(3/8 in.)
13mm
(1/2 in.)
[01]
[01]
[11]
[10]