Step 11: Add Door to Side Panel
Attach the Hinge Plates (p) by threading a Hinge Plate Screw (k) through each hole in the Hinge Plate and into the Side Panel as shown
in the Detailed View of Diagram 11. Repeat the process until both Hinge Plates are attached. Proceed to tighten the Hinge Plate Screws
with a phillips screw driver until tight.
To attach each Hinge (q) to its Hinge Plate, the bolt along the back center of the Hinge Plate must be loose during installation. The slot
on the end of the Hinge will fit around the bolt on the Hinge Plate. The top and bottom Hinges should engage at the same time as shown
in Diagram 11. Once the two parts of the Hinge are mated, tighten the bolt on the Hinge Plate firmly with a screwdriver.
Diagram 11
Detailed View
v
p
k
t
q
Step 12: Hinge Adjustment
Each hinge Assembly is adjustable in multiple directions. See Diagram 12 for assistance.
Diagram 12
Side Adjustment
Depth Adjustment
Height Adjustment
Sanus Systems
2221 Hwy 36 West, Saint Paul, MN 55113 9.29.05
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
