Step 3: Add second Side Panel Assembly
Attach the second Side Panel Assembly (t) by lining up and inserting both Front Rails (r) into the groove in the corner pillar. If the clamp
on the Front Rail will not fit in the groove, make sure the allen bolt (labeled in the Top View) is loose so the clamps are close together.
Once you have the Front Rails aligned so the bottom one is resting on the Foot (o), and the top one is level with the corner pillar, tighten
the allen bolt in the back of the Front Rail to widen the clamp to secure it to the pillar. See the Top View of Diagram 3 for assistance.
Top View
(Front Right Corner)
Diagram 3
allen bolt
t
r clamp
Step 4: Attach the Back Rails
Attach the Cam Pins (b) to the Back Rail (s). Make sure the arrow on each Cam is facing the hole in the outside of the Back Rail and add
two Cam Pins to each end of the Back Rail as shown in the Detailed View of Diagram 4. Insert the Cam Pins until there is a small space
between the head of the pin and the Back Rail.
Attach the Back Rail by sliding the cam pins down the groove on the Side Panel pillar as shown in the Top View of Diagram 4. Once the
Back Rail is resting on the Foot (o), tighten the cams labeled in Diagram 4 to hold it in place. Make sure the bottom Back Rail is oriented
so the threaded holes near the ends are on the top, and the Cams face inside the cabinet, as seen in Diagram 4. Make sure the top Back
Rail is oriented so the threaded holes near the ends are on the bottom, and the Cams face inside the cabinet, as seen in Diagram 4
Diagram 4
Top View
Detailed View
(Back Left Corner)
s
cam
b
t
b
s
