Sansui LCDVD150, Owner'S Manual

Page: 12 / 56

12
Inserting Batteries
1 2 3
Operation
• Aim the remote control at the remote sensor and
press control buttons to operate.
• Operate the remote control within 30
°
angle on
either side of the remote sensor, up to a dis-
tance of Approx. 5 meters.
Do not leave the remote control unit exposed to direct sunlight or in hot or humid places.
The remote control unit uses infrared beams to transmit signals, so sunlight or fluorescent light on the remote
sensor may shorten operating distance.
Incorrect use of batteries may cause them to leak or burst. Read the battery warnings and use the batteries
properly.
Do not mix old and new batteries.
Remove batteries if the remote control will not be operated for an extended period of time.
Approx. 5 meters
Remote control (continued)
NOTES:
•
•
•
•
•
To bundle the connected cable
Replace the compartment
cover. Install two "AAA" batteries
(supplied), paying attention to
the polarity diagram in the
battery compartment. Open the battery compartment
cover in the direction of the
arrow.
You can bundle the connected cables as follows.
1
While pressing on both
sides of the clip, remove it
from the unit while pulling
with an upward motion.
2
Gather up the cables
between the holes of the
cable holder.
3
Replace the holder.
5G30101A E P06-13 7/7/04, 14:10 12