Sanotechnik SANOSPA XXL1908, Instructions Manual

Page: 56 / 60

INSTRUCTION FOR USING THE SPA OUTDOORPOOL 56
6. DRAWING
Switch off the fuse before drawing.
Now you can omit water; you can either install the hose or let it run out.
Unscrew the cover (Picture 16) and rotate the back of the valve to the left to open it (Picture 17).
Now the water should drain. For almost complete emptying it is necessary to connect the pump,
since the outflow is slightly higher as the lowest point of the massage pool!
Attention!
If you empty the pool before winter time or prepare for the winter, empty the pool to the end so
that there is no water left. To ensure complete discharge, remove the connections on the pumps
and heating! Rinse the filter too!
Picture 14 Picture 15
Picture 16 Picture 17
5. WATER MAINTENANCE
When filling the massage pool, check the hardness of your water. If your water contains a lot of
limescale, add a water softener that protects the pool and pool technique from the limescale.
It is also important to chlorinate water before using the massage pool for the first time. Only use
fast-soluble chlorine granulate and not chlorine tablets or liquid chlorine. At the end of the process,
adjust the pH value (the value must be between 7.2 and 7.6). Use litmus paper to measure it.
IMPORTANT!
When placing chemicals in the massage pool, turn on all the massage pumps for 10 to 15
minutes to ensure that the agents are evenly moistened in the water.