7/20
6. Input/Output Connections
1) Vibratory feeder drive connection
Confirm that the power supply is in the OFF status. Then, connect the output cable of the
controller to the feeder cable of the piezo feeder.
The connector wire colors should be identified as follows:
※
1: Do not connect any feeder other than the piezo feeder made by Sanki.
※
2: Do not operate with no load.
※
3: Be sure to ground the feeder.
2) Power source connection
Connect the power cable to the single-phase power source.
Do not turn ON the power supply until the whole wiring work is completed.
※
1: Be sure to connect to the utility power source.
※
2: Be sure to ground the controller.
※
3: Do not perform the ON/OFF control on the input power supply side.
100-230VAC
Piezo feeder
Black
White
ピエゾフィーダ
Feeder cable
Summary of Contents for P212
Page 2: ......
Page 21: ...19 20 17 Outside Dimensional Drawing The input and output cables are omitted...
Page 23: ......
