SANKI MAGDRIVE CLAM, Operating And Service Manual

Page: 19 / 28

19
6-2. CORNER ROLLER TYPE CLAMC MODEL
● Single Drive Type
1. Remove drive unit top cover(*1) by loosening attachment bolts with a hexagonal wrench.
2. Remove geared motor(*3) by loosening attachment bolts(*2, 4 bolts).
3. Disconnect cable(*6) coming out of geared motor from control unit.
4. Remove crossed helical gear(*4) from geared motor(*3) removed in step 2 above.
5. Attach crossed helical gear(*4) (removed in step 4) to replacement geared motor.
6. Attach geared motor(*3) to corner base(*5) by tightening attachment bolts(*2, 4 bolts). (Make sure
that crossed helical gear of geared motor and line shaft side crossed helical gear are properly meshed.)
NOTE: Keep in mind that insufficient clearance between the crossed helical gears will cause premature
wearing of gears.
7. Connect cable(*6) of newly installed geared motor to control unit. (For 100/200V single-phase, see
p.10.)
8. Reinstall drive unit top cover(*1) in initial position with attachment bolts.
● Double Drive Type
Follow the procedures for gear driving type on p.18 and similarly replace geared motor.