6 www.sanitairecommercial.com
EN
Maintenance and Care
WARNING:
To reduce the risk of fire, electric shock or
injury, turn power OFF and disconnect plug from
electrical outlet before performing maintenance or
troubleshooting.
Machine Care
For best results, a few simple steps can
assure your machine is well maintained
after your cleaning is complete
1.
Turn power OFF. Unplug the machine
and wrap the Power Cord.
2.
After emptying the Clean and Dirty
Water Tanks, rinse them out with
running hot tap water.
3.
The top half of the Dirty Water Tank
can also be rinsed clean through the
nozzle area.
4.
After carpet is dry, vacuum again to
remove hair and fuzz.
4.
6B.
6A.
8.
10.
3.
5.
7.
9.
Belt Removal and Replacement
1.
Turn OFF the machine and unplug it
from the outlet.
2.
Remove the Dirty and Clean Water
Tanks from the base of the machine.
3.
While standing behind the unit, lay the
unit on its side (cord side up).
4.
Looking at the bottom of unit, find
the back center of the brush carriage
where the carriage latch is located. It
is between the brush assembly and the
front wheels.
5.
Pull brush carriage towards you with
one hand until it stops, then pinch the
carriage latch with other hand while
pulling the carriage towards you. The
carriage should swing out to access
belt cover.
6.
Remove three screws from cover. Lift
and remove to access brush carriage.
7.
Turn the belt inward towards the large
pulley while lifting out.
8.
Place new belt over small pulley first
and then slip the belt over the large
pulley.
9.
Replace the brush carriage and
screws.
10.
Push brush carriage back into place
making sure the carriage latch locks
back into place.
