26
EN
ENGLISH
Troubleshooting
Fault
Potential cause
→ Remedy
Sensor field does not light up when
approaching and no flush is actuated
•
No voltage
•
Technical defect
→ Check power supply
→ Call specialist
Sensor field does not light up when
approaching but flush is actuated
• Light mode for user
detection is disabled
→ Activate light mode see
“Settings"
Flush actuated too early
• Pre-flush active
→ see "Settings
Unintended flush actuation
• Sensor field is wet or
contaminated
• Sensor field is scratched
→ Clean actuator plate or dry it,
see "Maintenance"
Sensor field blinks
• Battery low
→ Replace battery
Water runs constantly into the urinal
• Technical defect
→ Call specialist
The sensor field blinks
MAGENTA,
1x blinking, set values
are applied when leaving the sensor range. By briefly co
-
vering the sensor field (1 sec.) it blinks 2 x
MAGENTA
and
the parameters II through V are set back to factory setting.
The sensor field switches to
GREEN
and blinks, parameter
for light mode. It is now possible to start anew with setting
or leave the sensing range.
VII Factory setting
1 sec.
Disposal
According to the WEEE - Directive 2012/19 of the European Parliament and of the
Council on waste electrical and electronic equipment – manufacturers of electrical
devices have to take back old devices and dispose the same in a proper manner.
The symbol shows that the product may not be disposed of together with household
waste. Old devices shall be returned to SANIT for proper disposal.