Sanit INEO BRIGHT, Assembly & Operating Instructions, Page: 23 / 28

23
EN ENGLISH
Manual setting
Settings Description Factory setting
I
(cleaning mode)
Stop function
Stops the flush function for cleaning. Flush function can be ena -
bled again after cleaning. Automatic activation after 3 minutes.
3 minutes
II Light mode
Person detection by light bar in sensor field can be switched
ON or Off.
The sensor field blinks if voltage is supplied by battery.
ON
III Power source
There is a choice between network or battery mode .
Service period extended by battery mode.
Sensor field only blinks when urinal is entered.
Power pack
IV Color
Setting of light color, selected can be:
RED/GREEN/BLUE
BLUE
V Main flush time
Flush time after use, flush times of 3, 4, 5, 6 and 8 seconds
can be set.
4 seconds
VI Dynamic flush
Water save mode, e.g. for stadiums, schools, restaurants,
cinemas, theatres…
Flush time reduced to 2.5 seconds if min. 3 users use the urinal
at a time distance of less than 1 minute. Switches automatically
back to normal when user interval is larger than 1 minute.
OFF
VII actory setting Resets the functions II, III, IV, V and VI to factory setting.
Keep the sensor field covered by hand at a distance of
about 4 cm. After a few seconds the actuator plate starts
blinking RED , then remove the hand.
Now, the cleaning mode is activated for 3 minutes. The
sensor field blinks RED two times every 6 seconds.
The cleaning mode is deselected automatically after
3 minutes or by a repeated covering of the sensor field
until it starts blinking RED quickly.
I Cleaning mode
3 minutes
6 sec.