Sanique S-3, User Manual

Page: 3 / 16

3
Check it ’ s on.
Turn pressure control knob clockwise to
increase pressure
Check plug & cable for loose connections
and/or damage
Make sure it ’ s in the prime position
Open prime valve and purge air from pump
Ensure it ’ s not clogged, clean where necessary
Tighten if loose
Tap the suction tube connection a few times to
loosen - if no result check that lower ball and/or
seat is not worn or scarred
Change packings ; contact a Sanique dealer or
technician for advice
Check not empty
If clogged, reverse tip , aim gun at scrap and
pull trigger to clear
Check tip for wear, replace where necessary
Check all filters are clear of debris, clean
or replace
Check not obstructed with debris, contact a
Sanique dealer or technician for advice
Check not obstructed with debris, contact a
Sanique dealer or technician for advice
3
Power switch
Pressure control knob
Supply plug & cable
Prime valve
Air in solution
Suction filter
Suction tube
Lower ball
Pump leaking
Solution bucket
Spray tip
Filters
Hose
Prime valve
Motor won ’ t run
Pump won ’ t
prime
Insufficient
pressure at the
gun or sudden
loss of pressure
SYMPTOM CHECK OUT PROCEDURE
Quick check
The information on this page is intended only as a quick guide. It is no way intended as
a substitute to the information on the pages following, which the user should be fully
acquainted with before using a Sanique sanitising sprayer.