10
HOSES
+
Tighten all of the fluid connections securely before each use. High pressure
solution can dislodge a loose coupling or allow high pressure spray to be
emitted from the coupling and result in an injection injury.
+
Only use hoses with a spring guard. The spring guard helps protect the hose
from kinks or other damage which could result in hose rupture and cause an
injection injury. Do not allow kinking or crushing of hoses or allow it to vibrate
against rough, sharp or hot surfaces.
+
Use only conductive fluid hoses for sanitising applications. Be sure the gun is
grounded through the hose connections. Only hoses as approved by Sanique
should be used with this sprayer.
+
NEVER
use a damaged hose, which can result in hose failure or rupture and
cause an injection injury or other serious bodily injury or property damage.
Before each use, check entire hose for cuts, leaks, abrasions, bulging of the
cover, or damage or movement of couplings. If any of these conditions exist,
replace the hose immediately.
+
NEVER
use tape or any device to try to mend the hose as it cannot contain
the high pressure fluid.
NEVER ATTEMPT TO RECOUPLE THE HOSE.
It is not possible to recouple a high pressure hose.
ASSEMBLY
1
Attach the hose to the pump and tighten with a wrench.
2
Attach the hose to the gun and tighten with a wrench.
OPERATION
1
New sprayer / before you start.
Your sprayer was factory tested in an oil
solution which was left in the pump. Before spraying, flush through with
warm water and detergent.
PACKINGS
The packings are a wearing part. If your Sanique sprayer can no longer maintain
pressure, has difficulty priming and tightening the packing nut no longer helps,
then the packings will require replacement. This is best entrusted to a qualified
Sanique repair technician.
Summary of Contents for S-3
Page 1: ...S 3 SANITISING ELECTRIC SPRAYER USER MANUAL ...
Page 12: ...12 ...
