background image

Installation

 

IMPORTANT! 

Install this product according to the installation guide. Spout must 

provide a minimum of 60mm reach for adequate clearance into bath. Our 

products must be installed by certified professional only and according to our 

installation guide as well as federal, provincial/state and local building codes and 

regulations.

Installation

 Requirements

Please read the instructions carefully and follow the specified guidelines so as to 

avoid any damage to the fixture. 

1.

The owner/user of the product must keep this information for future

 

reference.

2.

Consult local building codes to make sure the installation complies with

 

standards.

3.

Remove the unit from its packaging. Before disposing of it, inspect the unit to

 

make sure it is in good shape. Should inspection reveal any damage or defect in

 

the finish, contact your distributor. The warranty does not cover damages or

 

defects in the finish once it has been installed. The Manufacturer’s

 

responsibility

 

for shipping damages ceases upon delivery of the product in good

 

order to the

 

carrier. All complaints regarding damage due to transport must be

 

made.

4.

Place the unit in the bathroom before you start working. Conserve all nuts and

 

bolts.

5.

To protect the unit during installation, we recommend that you lay a piece of

 

cardboard on the bottom.

6.

If the unit is covered with polyethylene protective film, do not remove until

 

installation is complete to grant maximum protection. However, remove the

 

film where any two surfaces will be in permanent contact.

7.

Verify that all dimensions on the plan are the same as the ones of the unit.

Installation Notes

Reviews: