4
GB
Setting the clock
1. The clock will start running when the batteries are installed or when the radio is connected to an AC
Outlet. The display will show “ -- : -- -- ’’.
2. The time can only be set when the radio is switched off.
3. Press and hold down the Time Set button ( ) for approx. 2 seconds until the hours digits flash in
the display and a beep is heard.
4. Press the Tuning Up/Down buttons to set the required hour.
5. Press the Time Set button ( ), the minute digits will flash in the display.
6. Press the Tuning Up/Down buttons to set the required minute.
7. Press the Time Set button ( ) to complete time setting. The seconds will start to count. The radio
will display a 12 hour clock with an AM or PM indicator.
Operating your radio
Your radio is equipped with three tuning methods – Manual Tuning, Search tuning and Memory preset
tuning.
Manual Tuning
1. Press the Power button to turn on the radio.
2. Select the required frequency band by repeatedly pressing the Band button. For the FM frequency
band, pull out and extend the FM wire antenna located in the battery compartment to get best
reception. For the AM frequency band, rotate the radio for best reception, the antenna is built inside
the radio.
3. A single press on either Tuning up or Tuning down buttons will change the frequency in the following
increments:
FM: 100 or 200 kHz (USA version)
50 or 100 kHz (standard version)
AM: 9 or 10 kHz
4. When the frequency band end is reached, the radio will continue tuning from the opposite frequency
band end.
5. Press the Volume Up/Down buttons to the required level.
6. To switch off your radio, press the Power button. The display will show “OFF”.
