9
GB
Remote control battery replacement
1. Slide out the battery holder as shown.
2. Gently remove the batteries from the holder.
3. Insert 2 x CR2032 size batteries into the compartment with the positive side of the batteries
() facing upwards with the holder positioned as shown.
Note:
The remote control uses CR2032 batteries. For optimum battery life, fit batteries in
locations A and B. The control can also be used with a single battery installed in location
A but the battery life will be reduced. The control will not work if there is only a single battery
installed in location B.
4. Replace the battery holder as shown and ensure that the battery holder clicks into place.
5. If the remote is not to be used for an extended period of time it is recommended that the
batteries are removed.
IMPORTANT:
The batteries should not be exposed to excessive heat such as sunshine, fire or
the like. After use, disposable batteries should if possible be taken to a suitable recycling centre.
On no account should batteries be disposed of by incineration.
WARNING:
● Do not ingest the battery. Chemical Burn hazard.
●
The remote control supplied with this product contains a coin/button cell battery. If the coin/button
cell battery is swallowed it can cause severe internal burns in just 2 hours and can be fatal.
● Keep new and used batteries away from children. They can be a choking hazard.
● If the battery compartment does not close securely, stop using the product and keep it away
from children.
● If you think batteries might have been swallowed or placed inside any part of the body, seek
immediate medical attention.
CAUTION:
Danger of explosion if the battery is incorrectly replaced. Replace only with the same or
equivalent type.
CR2032
CR2032
A
B
Summary of Contents for DDR-75BT
Page 1: ...Version 1 DDR 75BT GB...
