Sanela SLO 02M, Mounting Instructions

Page: 7 / 7

11/2021
7
EN
More information
ATTENTION
Please read carefully and store safely this instruction sheet as important information about safety installation, using and maintenance. Incorrect installation
can cause harm to persons or property for which the manufacturer assumes no responsibility.
Quality tests during production phase guarantee maximum safety of using. Life cycle and overall electrical and mechanical features will be extended if the
device is used properly and with adequate maintenance.
Main technical characteristics:
Voltage / Frequency: 220-240 V / 50-60 Hz
Idle current in phase: < 25 mA
Max. phase current: 11 A
Rated power: 2400 VA
IP protection: IP 11B
Protection level: I
Noise level: 80 dB (inf. data)
Operating temperature: 5˚C - 45˚C
Air flow: > 75 l/s
Air speed: > 100 km/h
Devices fulfil the standards CEI.
Mounting instructions
The product installation may be carried out only by a qualified person with the relevant authorization according to the installation instructions and in accord -
ance with the regulations applicable at the place of installation.
Make sure that the power network and power of the network are adequate for appliance. The electric power supply must be protected by a single-phase
circuit breaker (min. 16 A). A residual current device can be used as additional protection.
The placement of the hand dryer in places close to the water source is subject to the applicable national standards at the installation sites. We recommend
installing the unit at a height of at least 120 cm from the floor to the air outlet of the dryer. For installation, use fasteners provided in the package. If the
power cord is damaged, it must be replaced by new, by the the manufacturer or by a person qualified to do.
Use
The hand dryer starts after pressing the mechanical button. The drying time is preset at the factory to 20 seconds, to restart, press the button again.
Notice
The device has a programmed security system to prevent vandalism and continuous operation. To restore function, remove obstructions from the air
exhaust.
Maintenance
Attention: Before performing any maintenance, disconnect the device from electrical power.
All stainless steel parts must be cleaned with water, soap and a soft cloth only. To ensure reliability and durability, make sure the air inlet and conical outlet
is not blocked by dirt, dust or larger particles. In any case, it is not possible to use aggressive and abrasive cleaners.
The manufacturer recommends cleaning the interior of dryer and control carbon engine parts minimal 2 times per year. Dirt sucked in the engine can cause
damage to the product. The maintenance of product may be carried out only by a qualified person with the relevant authorization according to the installa -
tion instructions and in accordance with the regulations applicable at the place of installation.
General warning
• Dryer are used exclusively for hand drying with hot air. Dryer may be used for drying the face by rotation of exhalation nozzle by 180°.
• The product must not be used for other purposes. The product is designed for indoor installation.
• Never leave the unit exposed to atmospheric agents (rain, sun, etc.)
• Do not tamper with internal components
• Do not block the air inlet or outlet
• Do not place any objects inside the device
Important information
This product fulfill standard 2012/19/EU (WEE2-OEEZ2) - recycling of electrical and electronic components. The device must be properly recycled.
Guarantee
The warranty does not include: vandalism, damage due to improper installation, damage due to modification of the equipment, transport damage, intention -
al damage and damage due to improper installation of the electrical network. The warranty also excludes consumables - carbon brusches.