1
1.1 Programming of Transmitter ID
When the Receiver is powered for the first time, the screen shows
“NSP”, which means there is no transmitter programmed into it. If the
user wants to program a new transmitter into the Receiver, the operation
should be finished in programming mode. At this time, make sure the
transmitter to be programmed has not been screwed onto the valve yet.
Screw on transmitters until the programming has been finished and the
Receiver returns to normal mode.
Each transmitter has 4 groups of ID, for example when program the
transmitter with ID of 001 001 001 158 to front right tire position, the
user only needs to input the last 3 digits “158”. Receiver will record the
rest 3 groups of ID automatically. Operation steps are as following:
1. After Receiver is powered, the screen will display “NSP”, press P for 3
seconds to access the system programming mode, the first interface is for
ID programming as shown below:
2. Press any of the four arrow keys to choose the tire position which
needs to be programmed with a transmitter.
3. Then press S for 3 seconds to start programming and the digit flashes,
then press up or down arrow key to adjust the number.
