KISS 2U Short V3 - User Guide, Rev. 1.1
// 47
Figure 39: Fan compartment without fan assembly
1.
Fan power control socket
2.
Fan compartment
5.
To replace with a new functional fan assembly, align the fan assembly with the fan compartment.
6.
Push the fan assembly carefully into the fan compartment until the fan assembly’s control connector
(Figure 12, pos2) is firmly inserted into the internal fan power control socket (Figure 39, pos. 1).
7.
Secure by fasten the knurled screws of the fan assembly (Figure 38, pos. 2)
8.
Insert the filter pad into the filter pad holder (both retained in step 1). Then reattach the filter pad holder to the
front side of the fan assembly as described in the Chapter 10.1: Cleaning the Filter Pad (steps 7 to 9).
10.3.
Replacing the Lithium Battery
Danger of explosion when replaced with wrong battery type
Replace only with the same or equivalent type recommended by the manufacturer.
The lithium battery type must be UL recognized.
Do not dispose of lithium batteries in general trash collection. Dispose of the battery
according to the local regulations dealing with the disposal of these special materials, (e.g.
collecting points for dispose of batteries).
To replace the lithium battery on the mainboard, proceed as follows:
1.
Switch off and disconnect the product from the mains power supply.
2.
Open the cover, as described in the Chapter 7.1: Opening and Closing the Cover (steps 1-4).
3.
If the product incudes expansion cards, first remove the expansion cards and all corresponding connecting
cables, to gain access to the lithium battery, see Chapter 7.2: Accessing Internal Components.
4.
Remove the lithium battery from the holder by pulling the ejector spring outwards.
5.
Place a new lithium battery in the battery holder.
6.
Pay attention to the polarity of the battery.
7.
Replace the lithium battery only with the same type of battery or with a type of battery recommended by
Kontron.
8.
Reinstall the removed expansion cards and reattach the connecting cables.
9.
Close the cover, as described in the Chapter 7.1: Opening and Closing the Cover (step 5).
2
1