KBox C-103-CFL-x - User Guide, Rev. 1.0
// 70
8.4.
Side Wall Mounting (Option)
Your KBox C-103-CFL can be mounted with optionally available side wall mounting brackets. The key holes of the
upper and lower mounting brackets (Figure 54, pos. 3 and pos. 6) allow you to mount the KBox C-103-CFL to a
mounting side of the control cabinet in vertical position. This is the only permitted operating position. The lower side
wall mounting bracket has different holes for mounting with and without fan tray (Figure 54, pos. 3 and pos. 4).
For a sufficient air circulation around the device, we recommend not to place (mount) or
operate any other devices within the “keep out area”. The clearances of “50mm” and
“100mm” around the KBox C-103-CFL must be observed; refer to the marked areas in Figure
46 to Figure 52. (This applies to the standard brackets as well as to the side wall mounting
bracktes.)
Prepare the mounting surface with four screws and if necessary anchors corresponding to the mounting surface type
(fire-resistant material). Please refer to the information for mounting to the section 12.1, “Mechanical Specifications
of the KBox C-103-CFL”, and the subsections 12.1.1 / 12.1.4 / 12.1.5 / 12.1.6 and 12.1.7, or refer to the drawings for
KBox C-103-CFL on our web site. The drawings can be downloaded from our web site www.kontron.com by selecting
the product.
Figure 54: KBox C-103-CFL-2 with fan tray and side wall mounting brackets
1
KBox C-103-CFL-2
2
Fan tray (optional)
3
Lower side wall mounting bracket with key
holes, mounted in the “with fan tray”position.
Red circles: Mounting holes for the lower side
wall mounting bracket if no fan tray is present
4
Mounting screws of the lower side
wall mounting bracket, using the
holes for mounting with fan tray
present
5
Mounting screws of the upper side
wall mounting bracket
6
Upper side wall mounting bracket
with key holes
2
6
1
3
5
4
