Sandstrom SHFTPPH10, Instruction Manual

Page: 11 / 32

11
Operating Your Remote Control
1. Press and slide the back cover to open the
battery compartment of the remote control.
2. Insert two AAA size batteries (not included).
Make sure the (+) and (–) ends of the batteries
match the (+) and (–) ends indicated in the
battery compartment.
3. Close the battery compartment cover.
OPEN
Handling the Battery
• Improper or incorrect use of batteries may cause corrosion or battery leakage, which could cause fi re,
personal injury or damage to property.
• Install the battery correctly by following the polarity (+ and –) indications in the battery compartment.
• When the battery is exhausted, the remote control will not function.
• Only use the battery type indicated in this manual.
• Do not dispose of the used battery as domestic waste. Dispose of it in accordance with local
regulations.
Handling the Remote Control
• Be aware of your fi ngernails when removing the battery cover and the battery.
• Do not drop the remote control.
• Do not allow anything to impact the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under direct sunlight or near sources of excessive heat.
• Remove the battery from the remote control when not in use for a long period of time, as corrosion or
battery leakage may occur and result in physical injury, and/or property damage, and/or fi re.
Remote Control Operation Range
Point the remote control at the unit no more than 6
metres from the remote control sensor and within
60° horizontally and 20° vertically of the front of the
unit. The operating distance may vary depending on
the brightness of the room.
Within about 6 m
30° 30°
• Make sure that there is no obstacle between the
infrared remote sensor of the unit and remote control. If
you install the unit on rack, etc., the remote controllable
range may decrease depending on the thickness or
colour of glass door of rack.
• Do not expose the infrared remote sensor to direct
sunlight or other strong light, such as inverter
fl uorescent light.