GB
15
Tips:
• Control the chopping time to prevent the food from becoming too finely chopped.
• Do not let the appliance run too long when you are chopping (hard) cheese. The cheese will
become too hot, start to melt and turn lumpy.
• Do not use the blade to chop very hard ingredients like coffee beans, turmeric, nutmeg and
ice cubes, as these may cause the blade to get blunt.
• If food sticks to the blade or to the inside of the bowl, turn the appliance off. Remove the
ingredients from the blade or from the bowl with a spatula.
Slicing / Shredding / Mashing Blade Disc
When you have to cut large amounts of food, process only small batches at a time and empty the bowl
regularly between batches.
Never process hard ingredients like ice cubes. Cutting edges are very sharp. Avoid touching them!
Knife Blade / Doughing Blade
The knife blade / doughing blade can be used for chopping, mixing, blending and pureeing.
1. Place the driving shaft down onto the centre post inside the bowl. Place the blade on the
driving shaft. Use only one blade each time.
2. Put the ingredients in the bowl. Pre-cut large pieces of food into small pieces. Put the lid on
the bowl.
3. Put the pusher in the feed tube.
4. Turn the control to Pulse (P) position.
Hold the Pulse (P) position for about 2-3 seconds and check your results. Repeat for desired
consistency. It is better to use several short operations rather than a single long one
unless mixing ingredients that require longer processing times.
After you have finished food processing, turn the control to 0 position. Allow the blade to
stop running.
Carefully remove the blade from the bowl. Unlock the bowl and lift the bowl off. Empty the
processed food.
The cutting edges of the blade are very sharp. Avoid touching them!
1. Put the bowl on the motor unit, turn the handle to lock into place and fit the driving shaft
onto the centre post.
2. Insert the slicing / shredding / mashing blade disc onto the blade disc holder. Place the blade
disc holder inside the bowl. Use only one blade each time.
3. Put the lid on the bowl.
4. Put the ingredients in the feed tube. Pre-cut large chunks to make them fit into the feed tube.
5. Fill the feed tube evenly for the best results.
6. Select the preferred processing speed on the control.
7. Press the pusher lightly onto the ingredients in the feed tube.
S10AFP14E_IB_5L_140929_grace.indd 15
29/9/14 2:49 pm
