21
ENGLISH
• By using the speed selector
, you can set the speed of the fan:
Fast Speed: Hi
Slow Speed: Low
Timer operation
By using the button
, the user can program a period of operation between 1h and 24h. At
the end of the programmed period the device stops completely.
During the timer period, the display shows the time programmed, and the indicator
is illu-
minated, indicating that the device is programmed to function for a limited time period.
Self-defrost cycle
The normal operating temperature range is +5ºC/+32ºC. Operation of the device outside this
range is not recommended.
The self-defrost function is initiated automatically by the device itself. It is activated for a period
of 5 minutes if the ambient temperature is below 15ºC approximately. When this function is
activated, the self-defrost indicator light
illuminates.
Self reset function
The device is equipped with a self reset function. In the event that the power supply is cut
temporarily for any reason, the unit resets itself automatically, retaining the parameters set by
the user before the power cut.
REMOVAL OF WATER
Removal of water by means of the tank
1. An intermittent sound signal accompanied by the illumination of the red light
, indicate
that the water tank is full. The device will cease to operate until the user empties it (Fig. 3).
2. Once emptied, replace it inside the unit. When the indicator
goes out, this indicates that
the tank has been replaced correctly.
Precautions:
Do not remove the tank too often. If this action is repeated over a series of short
periods, damage can be caused to the compressor. Wait until the tank is completely full.
Continuous water drainage
1. Remove the water tank, so that you can connect the pipe to the water outlet tube (Fig. 3).
2. Connect a PVC pipe with an interior diameter of 14 mm to the water outlet tube and secure
it with a nylon hose clip. The extraction tube must always be flat to the floor and free of any
kink that might obstruct the flow of water.
3. Replace the water tank in the unit, and the latter will restart operating after 3 minutes ap-
prox.
