4
1. INTRODUCTION
Thank you for purchasing this appliance. It has been manufactured in full compliance with applica-
ble safety regulations and EU standards.
Please read this instruction book carefully, as it contains important information for your safety
during the installation, use and maintenance of this product.
Keep it at hand for future reference.
Please check that the appliance is in perfect condition when you unpack it, as all factory defects are
covered by the
S&P
guarantee.
2. SAFETY REGULATIONS AND “CE” MARKING
S&P
technicians are fi rmly committed to research and development of ever more effi cient products
and in compliance with current safety regulations.
The instructions and recommendations given below refl ect current regulations, principally regar-
ding safety, and therefore are based on compliance with general regulations. Therefore, we recom-
mend all people exposed to hazards to strictly follow the safety regulations in force in your country.
S&P
will not be held liable for any possible harm or damage caused by non-compliance with the
safety regulations, as well as caused by modifying the product.
The
CE
mark and the corresponding declaration of conformity are proof of the product’s conformity
with current EU regulations.
3. GENERAL INSTRUCTIONS
A hazard analysis of the product has been carried out as provided in the Machine Directive. This
manual contains information for all personnel exposed to these hazards, with the aim of preventing
possible harm or damage due to faulty handling or maintenance.
All maintenance operations (ordinary and extraordinary) must be carried out with the machine
switched off and the electrical power supply disconnected.
To avoid a possible accidental start up, place a warning notice on the electrical control panel with
the following text:
“Attention: control disconnected for maintenance operations”
Before connecting the power supply cable to the terminal strip, make sure the mains voltage co-
rresponds to the voltage indicated on the specifi cations plate of the unit.
Regularly check the product labels. If, due to the passing of time, they are no longer legible, they
must be replaced.
4. UNIT LABELLING
The machine may come with several pictograms that must not be removed. These signs are divided
into:
•
Prohibition signs:
Do not repair or adjust when in operation.
•
Danger signs:
Warning of the presence of live elements inside the container bearing the sign.
•
Identifi cation signs:
CE card, indicating product information and manufacturer’s address. The
CE mark indicates the product’s conformity with EEC standards.
Summary of Contents for CADB HE ECOWATT Series
Page 1: ...EN CADB T HE ECOWATT 2018...
Page 2: ......
